[ ← GO TO AD ]

Harig 618


Listed For Sale at MachineKs.com in category - Surface Grinders, Hand Feed.
 
[ TRANSLATOR ]
6 Width 18 Length Harig 618 SURFACE GRINDER, TOOL STEEL HARDENED WAYS, PM
 Ad Id#: 19548
 Seller Ref.# 153579
 Model: 618
 Make: Harig
 Year: 1984 ( Used )
 Price: $0.00
 Location: USA
Ad Status:CLOSED
Listed By:Machinery Values Inc.
 Address: 
401 Supor Blvd.
Harrison NJ 07029
USA
Phone: 973-497-7505
Fax: 973-497-7501
 Description: 
 6" X 18" HARIG (MADE IN USA) "PRECISION"  HAND FEED SURFACE GRINDER  S/N:5880-W   NEW: 1984  WIDTH & LENGTH GROUND ........................ 6" X 18" VERTICAL WORKING HEIGHT UNDER 7" WHEEL ........ 11- 3/4"LONGITUDINAL TABLE TRAVEL ......................... 20"CROSS TRAVEL ................................... 6- 3/4"GRINDING WHEEL ..................... 7" X 1/2" X 1-1/4"MAXIMUM GRINDING WHEEL DIAMETER .................... 8"ELEVATING HANDWHEEL GRAD. ..................... 0.005"CROSS HANDWHEEL GRAD. ......................... 0.001" FLOOR AREA OPERATING SPACE .................. 69" X 45"APPROXIMATE WEIGHT .......................... 1,250 LBS EQUIPPED WITH: WIDE BASE FOR INCREASED STABILITYTOOL STEEL HARDENED WAYS OPTIONAUTOMATIC LUBRICATION SYSTEM6" X 18" WALKER CERAMAX FINE-DIVISION PERMANENT MAGNETIC CHUCK 1 HP 3/60/230-460 VOLT HARIG SUPER-PRECISION DIRECT DRIVE CARTRIDGE TYPE SPINDLEMACHINE IS PRESENTLY WIRED FOR 230 VOLTS ** INSPECT UNDER POWER IN OUR HARRISON, N.J. WAREHOUSE ** ** EXCELLENT CONDITION & APPEARANCE **   


NOTE: Displayed on page Harig 618 6 Width 18 Length Harig 618 SURFACE GRINDER, TOOL STEEL HARDENED WAYS, PM is listed under ID# 19548 by Machinery Values Inc. in category Surface Grinders, Hand Feed. For any additional info regarding this Harig 618 please contact directly Machinery Values Inc..

© MACHINEKS.COM All Rights Reserved